How To Install Your OK Machine Easily (No Professional Needed)

🇬🇧 Okey table – Installation Guide
Thanks for choosing the OK Machine.
This guide is written to help you set it up step by step, even if you've never installed anything like this before. Just follow along slowly, no need to rush.
What's inside the box
Before you start, quickly check everything is there:
Main OK machine unit (fully assembled inside, do not open)
4 support legs
Left bracket + right bracket
Screw set
Screwdriver
Power cable (220V)
User manual (some versions include a QR video guide)
Side panels (depending on your model)
If anything is missing or damaged, stop and contact support first.
Before installation
A few simple but important things:
Place it on a flat and solid floor
Leave enough space around it so you can move freely
Keep the area dry
If possible, have 2 people for lifting later
Most problems come from uneven floors, so don't ignore this.
Step 1 – Place the main unit
Put the machine upside down on something soft (like cardboard or foam).
Just make sure:
It's stable
It doesn't wobble
The surface won't scratch it
That's it.
Step 2 – Install the legs
Now attach the 4 legs.
Line them up with the screw holes
Put all screws in first, but don't fully tighten yet
After all legs are in place, tighten them slowly and evenly
Go in a cross pattern instead of tightening one side first.
✔ You did it right if:
The machine stands evenly
No wobble when pressing corners
If it tilts:
Loosen everything and redo the tightening order.
Step 3 – Install the brackets
Take the left and right brackets.
Match them to the correct side
Slide them gently into position
You should feel a small "click" when they lock in
Then fix with screws
If it doesn't fit easily, don't force it. Check the direction again.
✔ Correct:
Fully seated, no gap
Wrong:
Not going in → usually wrong angle
Step 4 – Side panels (if included)
If your set includes side panels:
First connect them into a full frame
Then attach them to the machine
Press gently until they lock in place
✔ It should feel solid, not loose.
Step 5 – Stand it up
This step needs two people.
Hold both sides
Lift slowly
Place it down gently on all four legs
✔ Correct:
All legs touch the ground evenly
Wrong:
One side lands first → restart the step
Step 6 – Power test
Plug it into a standard 220V socket and turn it on.
Run it a few times and check:
✔ Smooth movement
✔ No shaking
✔ No strange noise
If something feels off:
Noise → check screws
Stuck movement → check alignment
Shaking → check floor level
Final check
Press each corner lightly:
No movement → good
Wobble → adjust the legs
Even a small uneven floor can affect performance.
Safety tips
Don't force any moving parts
Don't open the internal structure
Recheck screws after a few days of use
Keep away from water
Unplug when not in use for long periods
That's it
If you followed everything above, your OK Machine should be ready to use.
Most issues come from:
uneven floor
loose screws
bracket not aligned properly
Fix those and everything works fine.